The 2D-Datarecording-Forum
The Experts in data aquisition
2D Datarecording, the ultimate in sensors, measurement systems and data aquisition 		 
You are not logged in.
LoginLogin Join for freeJoin for free
MessagesMessages SearchSearch HelpHelp StatStatistics
VotesVotes FilesFiles CalendarCalendar BookmarksBookmarks
problem with minidash display
The 2D-Datarecording-Forum / Software

  Reply to this message First   Previous   Next   Last
Author Message
gilles27
Registrierter Benutzer


Messages: 2
New PostCreated: 2006-11-20, 02:29 PM CET  Subject: problem with minidash display  print  print thread  recommend Reply with Quotation  
Hello, my minidisplay send me a message " No Can identified"
and with "Winit", i can not see the Dashmini in the windows.
people know why??
thank

[edited: 2006-11-20, 03:42 PM CET by gilles27]
back to top
Show user's profile Send private message to this member
Saftschubser
Registrierter Benutzer


Messages: 3
New PostCreated: 2006-11-21, 03:13 PM CET  Subject: Re: problem with minidash display  print  recommend Reply with Quotation  
HI,
the problems should be the cable to your dashboard!
This message comes when the display see no data on the can line.
check:
  • check all connections and the cable for damage
  • can you measure a resistance of about 120 or 60 Ohm between CAN HI and CAN Lo ( pin 1 and 2 of the logger connector)?
  • check with Winit in Logger ->interface->CAN if the right baudrate is selected. ( should be 1MBaud)
back to top
Show user's profile Send private message to this member
gilles27
Registrierter Benutzer


Messages: 2
New PostCreated: 2006-11-21, 03:19 PM CET  Subject: Re: problem with minidash display  print  recommend Reply with Quotation  
thank, i will test.
back to top
Show user's profile Send private message to this member
Sortierung ändern:  
  Reply to this message The 2D-Datarecording-Forum / Software First   Previous   Next   Last
Page 1 of 1
Go to:   
Search

powered by carookee.com - group communication for you

Layout © subBlue design